Measuring the line pressure
- Connect the pressure gauge according to Connecting fuel pressure gauge
- Remove the soundproofing panel
- Remove the fuel pump (FP) relay (CMI 12 in the passenger compartment)
- Connect a cable to the relay base as illustrated.
Read off the line pressure from the pressure gauge. The line pressure must be 375-395 kPa
Check the residual pressure if the fuel pressure is OK.
Remedy as necessary
Other information
- For the location of and to replace the fuel pump (FP) relay, see Central electronic module (CEM), replacing
- For the location of and to replace the fuel pump (FP), see Right side fuel pump with level sensor
- See Replacing the fuel filter
- To disconnect the pressure gauge, see Disconnecting fuel pressure gauge .
Is the rest pressure to be checked?
- YES
Refer to Checking the residual pressure
- NO
OKAY: Troubleshooting has been completed.