LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2000 >> S70 GLT SE >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Hub >> Installation

Removal & Installation: Hub: Installation

  1. Ensure axle shaft is clean. Install hub. Install NEW nut on axle and tighten to 88 ft. lbs. (120 N.m), then tighten an additional 120 degrees. Ensure no play is present in bearing. Using Mandrel (5225), install protective cover.
  2. Ensuring contact surfaces on disc and hub flange are clean, install disc and guide pin. Tighten guide pin to 84 INCH lbs. (10 N.m). Adjust parking brake shoes until brake disc cannot be rotated, then loosen 4-6 notches. Using NEW bolts, install brake caliper. Tighten caliper bolts to 44 ft. lbs. (60 N.m). To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals