LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2000 >> S70 GLT SE >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Anti-Roll Bar >> Installation

Anti-Roll Bar: Installation

  1. Install anti-roll bar with NEW nuts and bolts. Do not tighten nuts and bolts at this time. Using NEW bolts and nuts, install transverse arm mounting to trailing arm, installing NEW inner bolt and nut first. Adjust mounting in relation to previous reference mark and install second bolt and nut. Tighten nuts to 37 ft. lbs. (50 N.m), then tighten an additional 150 degrees.
  2. Tighten anti-roll bar right side bolts to 37 ft. lbs. (50 N.m). Tighten left side forward bolt to 37 ft. lbs. (50 N.m), plus an additional 120 degrees. Tighten left side rear bolt to 66 ft. lbs. (90 N.m). Cut plastic tie used to suspend muffler and reinstall muffler rubber support.
scientia non olet · About LEMON Manuals