Steering Wheel & Contact Reel: Installation
- If contact reel locking bolt is not in lock position, contact reel must be centered before installation. See CONTACT REEL CENTERING under ADJUSTMENTS. To install, reverse removal procedure. Tighten contact reel mounting screws to 22 INCH lbs. (2.5 N.m) and steering wheel retaining bolt to 30 ft. lbs. (40 N.m).
- Turn ignition switch to ON position. Connect negative battery cable. Ensure system is functioning properly. See SYSTEM OPERATION CHECK . If an air bag module fault code exists after replacing air bag module, clear codes and perform SYSTEM OPERATION CHECK again. If SRS warning light still indicates a malfunction, enter self-diagnostics and retrieve fault codes. See DIAGNOSTICS .
Courtesy of VOLVO
Courtesy of VOLVO