Flywheel Adaptation Completed

Adaptation of the flywheel is done when:

• Engine speed (RPM) is between 2300 RPM and 3000 RPM
• The load should exceed 40% of relative load, which corresponds to normal forward travel on a smooth road at approximately 100 km/h.

Flywheel adaptation takes approximately 60 seconds. Drive line oscillations, caused by uneven road surfaces for example, may lead to uneven engine operation. Drive line oscillations will be registered by the ABS system and the information sent to the ECM. The ECM uses this information to differentiate between these oscillations and real misfiring. Misfire diagnostics are shut off in the event of drive line oscillations.