Rear Disc: Removal
- Remove wheel.
- Push out split pins with a .12" (3 mm) mandrel.
- Remove retaining spring.
- Remove brake pads and shims. Use puller if brake pads will not come out easily. See Fig 1.
- Remove and discard both caliper mounting bolts and remove brake pipe from clips. If removing LH brake caliper you will also need to remove the brake pipe three-way connector mounting bolt.
- Remove brake caliper.
- Hang brake caliper on a steel wire in the spring so as not to damage brake pipe.
- Undo parking brake adjusting screw until brake disc can be removed. Access the adjusting screw by turning the brake disc until the adjustment hole is centrally over the adjusting screw which sits between the brake shoes.
- Unscrew locating pin and remove brake disc.
CAUTION:
Manufacturer recommends using NEW brake caliper mounting bolts.