LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2000 >> S70 GLT SE >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brakes - Repair >> Removal & Installation >> Master Cylinder >> Installation

Master Cylinder: Installation

  1. Check that there is no dirt in the master cylinder connections and that the packing box is intact.
  2. Install master cylinder and EBD pressure sensor using new nuts. Tighten nuts to specification. See TORQUE SPECIFICATIONS .
  3. Remove plugs from brake pipe and connect brake pipe. Connect connector to EBD sensor. Install brake fluid reservoir.
  4. Bleed braking system. See BLEEDING BRAKE SYSTEM . Clean off any brake fluid spillages with lukewarm water and car-wash shampoo.
scientia non olet · About LEMON Manuals