Master Cylinder Reservoir: Installation
- Inspect brake fluid reservoir, level sensor, non-return valves and seals. Use new seals if necessary. Clean carefully any components not being replaced of old brake fluid and dirt using new brake fluid.
- Install brake fluid reservoir. Check that there is no dirt in the connections. Grease "O" rings and any hoses with brake fluid or glycerine.
- Install brake fluid reservoir from directly above. Bolt on underside of brake fluid reservoir. Fill brake fluid reservoir with new brake fluid. Connect hose to brake fluid reservoir. Remove hose pliers.
- Connect connector to brake fluid level sensor. Check that there are no leaks. Clean up any brake fluid spillage with lukewarm water and car-wash shampoo.