Removal & Installation (C70, S70 & V70 - Right Side With A/C)
- Turn ignition switch to OFF position. Disconnect negative battery cable. Remove control module box air duct on right side of engine compartment. Remove washer reservoir filler pipe.
- Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove A/C receiver-drier (located behind headlight). Remove wiper arm and washer hose. See HEADLIGHT WIPER ARMS under REMOVAL & INSTALLATION.
- Remove headlight and side-marker assembly. Remove control module box security strap. A screw puller will be needed for the bolt on the strap. Drill hole and use screw puller to remove strap bolt. Remove security strap. Before removing control module box cover, clean debris off to prevent damage to module.
- Remove upper control module box bolt on right front of box. Pry out metal clip for control module box cover and remove cover. Pry out metal clips for lower control module box and remove middle section.
- Move control module backward to release from tab in front of box. Access headlight wiper motor from under control module box cable ducting. Remove 3 radiator support screws ("A") and 2 screws ("B") retaining wiper motor. See Figure . Remove wiper motor through engine compartment. Rotate wiper motor 1/2 turn to ease removal.
- To install, reverse removal procedure. Use new security bolt for security strap on control module box. Tighten bolt until the head breaks off. Adjust wiper arm as necessary. See HEADLIGHT WIPER ARM ADJUSTMENT under ADJUSTMENTS.