LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2000 >> S70 GLT SE >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Power Seats >> Diagnostic Tests >> DTC 214: Motor No. 3 Turning In Wrong Direction

DTC 214: Motor No. 3 Turning In Wrong Direction

  1. This DTC will set if seat control module receives a signal from motor No. 3 potentiometer that motor No. 3 is turning in the wrong direction. To correct this problem, check seat rear up and down movement with control button and memory buttons. If seat moves in proper direction, go to step  3 . If seat does not move in proper direction, go to next step.
  2. Turn ignition off. Remove seat from vehicle. See POWER SEAT  under REMOVAL & INSTALLATION. Disconnect seat control module 14-pin Black connector. See Figure . Press out seat control module 14-pin Black connector terminals No. 3 (Yellow wire) and No. 4 (Green wire). Reposition wires in connector, reversing terminal positions. Retest system.
  3. Turn ignition off. Remove seat from vehicle. See POWER SEAT  under REMOVAL & INSTALLATION. Disconnect seat control module 14-pin Black connector. See Figure . Ensure Brown wire is connected to terminal No. 14 and Red wire to terminal No. 7. See Figure . If wires are in wrong position, reposition wires in connector. Retest system. If wires are not in wrong position, replace seat control module. See SEAT CONTROL MODULE  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals