LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2000 >> S70 GLT SE >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Power Seats >> Diagnostic Tests >> DTC 144: Motor No. 2 Turning In Wrong Direction

DTC 144: Motor No. 2 Turning In Wrong Direction

  1. This DTC will set if seat control module receives a signal from motor No. 2 potentiometer that motor No. 2 is turning in the wrong direction. To correct this problem, check seat back forward and backward movement with control button and memory buttons. If seat moves in proper direction, go to step  3 . If seat does not move in proper direction, go to next step.
  2. Turn ignition off. Remove seat from vehicle. See POWER SEAT  under REMOVAL & INSTALLATION. Disconnect seat control module 14-pin Gray connector. See Figure . Press out seat control module 14-pin Gray connector terminals No. 1 (Green wire) and No. 2 (Black wire). Reposition wires in connector, reversing terminal positions. Retest system.
  3. Turn ignition off. Remove seat from vehicle. See POWER SEAT  under REMOVAL & INSTALLATION. Disconnect seat control module 14-pin Gray connector. See Figure . Ensure Blue/White wire is connected to terminal No. 5 and Yellow/White wire to No. 4. See Figure . If wires are in wrong position, reposition wires in connector. Retest system. If wires are not in wrong position, replace seat control module. See SEAT CONTROL MODULE  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals