Installing the bumper

Fig 1: Bumper Clips And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

If the car is equipped with headlamp wipers fold the headlamp wipers forward.

Install: 

• the bumper
• the two clips (A)
• the four screws. Tighten to 40 Nm  to the bumper.

Fig 2: Air Baffle And Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the switch for the fog lamp
• the switch for the sidemarker lamps
• the air baffle.

Fig 3: Cable Harness Clip And Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the screw (A) on the left and right-hand sides
• the clip (B) for the cable harness in the bumper
• the right and left-hand turn signal lamp.

If necessary install: 

• the hose for the headlamp wiper by the T-coupling
• the coupling for the headlamp wiper
• the outside temperature sensor.