Child seat, ISOFIX mounting

WARNING: Never place the child seat on the front passenger seat if the car is equipped with activated SRS (Airbag) on the passenger side. If you have difficulties installing a child safety product contact the manufacturer for clearer installation instructions.

NOTE: It is recommended that an authorized Volvo workshop carries out the installation of this accessory.

Fig 1: Fold Backrest Forward

Courtesy of VOLVO CARS OF NORTH AMERICA.

For cars with power seats

Adjust the front seat to its lowest position, both at the front and rear edge, to facilitate the installation of Isofix.

Applies to all cars

Fold the backrest forward.

Fig 2: Insert U Bracket Through SIPS Tube From Underneath, Thread Anchor Mounting Onto U Bracket & Tighten Nuts

Courtesy of VOLVO CARS OF NORTH AMERICA.

Push the upholstery and padding at the side of the SIPS tube to one side.
Insert the U bracket (1) through the SIPS tube from underneath. The U bracket studs must protrude outwards towards the upholstery on top of the SIPS tube.
Make a cut in the upholstery for the studs. Use a knife.
NOTE: Take care not to damage the heated seat cushion.
Insert the U bracket.
Thread the anchor mounting (2) onto the U bracket. Ensure that the anchor mounting lies against the SIPS tube.
Install and tighten the nuts (3). When tightening the nuts, take care to tighten them alternately to prevent distortion of the mountings. Also take care to conceal any upholstery and foam that may come between the anchor mounting and SIPS tube. These must lie be opposite each other after tightening. Tighten to 7 Nm (5.3 lbf. ft.) .
Install the rubber caps (4) from the kit, on the protruding studs.

Fold the backrest back into place.