Right drive shaft, reinstall: Install:

Fig 1: Locating Control Arm/Ball Joint And Anti-Roll Bar Link Bolts

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Control arm/ball joint to axle shaft. Remove holder 9995563 and sleeve 9995562 from ball-joint. Ensure that the ball joint pinion groove lines up with the screw hole in the stub axle. Use new lock nut on bolt. Tighten to 50 Nm  .
• Anti-roll bar link. Use new lock nut. Tighten to 50 Nm  .

Fig 1: Identifying Brake Line/ABS Cable Bracket And ABS Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Bracket for the brake line/ABS cable.

Clean the ABS sensor first using a soft brush. Then install the small wheel spindle and tighten to 10 Nm  .