Installing the power steering pump

Fig 1: Power Steering Pump

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the power steering pump in the correct position
• the screws, x 3, through the pulley.

Install: 

• the auxiliaries belts. Use 9997109 wrench 999 7109
• the connector for the engine coolant level sensor
• the coolant reservoir and the power steering reservoir in their mountings
• the hoses in their holders and clips
• the intake hose for cold air to the control module

Turn the ignition key to position 2.

Connect the battery negative lead to the battery negative terminal.