Checking cables

Check the cable between overload relay 2/30 terminal 3 and the RTI control module #B2 for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .

Check control cable between overload relay 2/30 terminal 3 and ignition switch for a short-circuit to supply voltage for a short-circuit to supply voltage Short-circuit to supply voltage. Permanent faults .

If no faults are detected in the cables, try a new relay.

Remedy as necessary.

Other information: 

• For further information about the circuit after the ignition switch, see the Service Manual Wiring Diagram.

Fig 1: Identifying Control Module Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  OKAY:  Troubleshooting has been completed.