Faulty signal.: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Connecting Control Unit

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Reconnect connectors, reinstall components.
• Disconnect the Volvo Scan Tool (ST) from the VIDA station. Use it in stand alone mode and connect it to the data link connector (DLC) in the car.
• Ignition on.
• Use System test function to test if the TMC/FM receiver is OK. For more information about System test, see System Test . The test can take up to approximately 6 seconds at longest.

  Check if the TMC/FM receiver is OK.

  Fig 4: Identifying Scan Tool

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the TMC/FM receiver OK? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Information