Check the CD-ROM disc, contact resistance and oxidation

Check control module and CD-ROM player connectors for contact resistance and oxidation and remedy according to Contact resistance and oxidation .

Clean CD-ROM disc

Check that CD-ROM disc is undamaged. If the CD-ROM disc appears damaged, try a new CD-ROM disc.

Disconnect the Volvo Scan Tool (ST) from the VIDA station. Use it in stand alone mode and connect it to the data link connector (DLC) in the car.

Ignition on.

Insert a CD-ROM disc with map information into the CD-ROM player.

Use System test function to test CD-ROM player functions. For more information about the System test, see System Test . The test can take up to approximately 4 minutes at longest.

Other information: 

• To access/replace the control module, see Replacing the control module, old system .
• To access/replace the CD-ROM player, see Replacing, CD-ROM player .

Check that CD-ROM player is OK.

If the CD-ROM player function is now OK, the fault was due to a bad connection or a fault with the CD-ROM disc.

Is the CD-ROM player OK? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Check, cables and components