Internal fault: Verification

HINT: After carrying out the repair, check that the fault has been remedied.

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Connecting Control Unit

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Reconnect connectors, reinstall components.
Disconnect the Volvo Scan Tool (ST) from the VIDA station. Use it in stand alone mode and connect it to the data link connector (DLC) in the car.
Ignition on.
Use System test function to test the control module circuits (GPS). For more information about the System test, see System Test . The test can take up to approximately 40 seconds.
Check if the control module is OK or not.

If control module works OK is displayed.

Fig 4: Identifying Scan Tool
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the control module OK?