Reading the odometer setting, km
Programming the odometer setting (new combined instrument panels only).
The odometer setting can be programmed between 0 and 999999 km. It is only possible to program this parameter once and then only if the reading is below 500 kms.
The upper field displays YES if the mileage can be programmed. If programming is not permitted NO is displayed. This means either that the mileage has been programmed before or that the mileage has exceeded 500 kms. The actual stored mileage is displayed in the next upper field.
To program the mileage enter the required value in km. Select Confirm if the value is correct. Then select Start programming.
After programming is complete, NO is displayed in the uppermost field. The programmed distance is displayed in the lower field.
Programming can only be carried out ONCE so take care when setting the mileage.
To ensure that the service interval for the service reminder indicator (SRI) functions correctly after a combined instrument panel has been replaced, the procedures for setting the service reminder indicator (SRI) to zero must be carried out.
- Continue
OKAY: Troubleshooting has been completed.