Diagnosis (Faulty Signal, Permanent Fault)
- Ensure A/C system is functioning correctly. If A/C system is not operating correctly, repair as necessary. If A/C system is OK, try a new air conditioning (A/C) pressure sensor. Go to next step.
- Verification After carrying out the repair, check that the fault has been remedied as follows:
- Turn ignition off
- Air conditioning (A/C) pressure sensor and engine control module (ECM) connected
- Start the engine and idle it
- Air conditioning (A/C) switch on
- Blower fan on
- Wait until the air conditioning (A/C) compressor has started
- Select Volvo Scan Tool, or aftermarket scan tool, to read off DTCs. If EFI-225 is stored it should have intermittent status.