Verification of non-sticking brakes: Verification

HINT: After repair, it is necessary to check that the fault no longer exists. 

HINT: Perform as follows: 

Fig 1: Identifying Ignition Switch OFF Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Reconnect connectors, components etc.
  • Raise vehicle so all wheels hang freely.

Check that all wheels can be turned easily. Brakes are not allowed to stick. 

• OK 

  VERIFIED:  Troubleshooting has been completed.

• NOT OK 

  VERIFICATION FAILED:  The fault should have been detected and remedied. As this is not the case fault-tracing has failed. Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.