Verification of brake circuit warning indicator function: Verification

HINT: After repair, it is necessary to check that the symptom no longer exists. 

HINT: Perform as follows: 

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Reconnect connectors, components etc.
• Start engine.
• Rev engine up once.
  Fig 3: Identifying Brake Warning Display

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  • HINT: The brake circuit warning indicator should not come on if the brake fluid level is correct. 
  • Remove the reservoir cap. Lift up the brake fluid sensor and let the float mechanism hang freely.
  • NOTE:

    Place rags under the brake fluid reservoir in to order avoid brake fluid spillage on painted surfaces.

Check that the brake circuit indicator comes on. 

• OK 

  VERIFIED:  Troubleshooting has been completed.

• NOT OK 

  VERIFICATION FAILED:  The fault should have been detected and remedied. As this is not the case fault-tracing has failed. Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.