Removing Power Steering Pump

Fig 1: Removing/Installing Delivery Pipe On Power Steering Pump

Courtesy of VOLVO CARS OF NORTH AMERICA.

Place paper towels under the power steering pump to absorb any power steering pump fluid.

Install a hose clamp on the power steering pump hose

Remove the pressure line from the power steering pump. Plug the power steering pump and pipe using rubber plugs.

Disconnect the connector from the belt cover above the power steering pump.

Fig 2: Power Steering Pump Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the power steering pump's 3 x mounting screws through the pulley holes.

Remove: 

• The servo hoses and the engine coolant hoses from their holders/clips. Remove the tie strap for the servo hose by the suspension turret
• The servo reservoir from its mounting on the expansion tank for coolant
• The connector and place the servo reservoir on the engine.

Place the power steering pump on the engine.

Fig 1: Power Steering Pump Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the power steering pump's 3 x mounting screws through the pulley holes.

Remove: 

• The servo hoses and the engine coolant hoses from their holders/clips. Remove the tie strap for the servo hose by the suspension turret
• The servo reservoir from its mounting on the expansion tank for coolant
• The connector and place the servo reservoir on the engine.

Place the power steering pump on the engine.

Remove: 

• The servo hoses and the engine coolant hoses from their holders/clips. Remove the tie strap for the servo hose by the suspension turret
• The servo reservoir from its mounting on the expansion tank for coolant
• The connector and place the servo reservoir on the engine.

Place the power steering pump on the engine.