Install the flame trap (Earlier version)

NOTE: Earlier version:

Fig 1: Identifying Flame Trap Seals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install new seals on the flame trap (lubricate the seals), tighten the seals to 20 Nm .

Install the intake manifold bracket loosely with the lower screw.

NOTE: If the flame trap tip / turns when tightening, make sure that the seals have not rubbed of their necks on the flame trap.

NOTE: Earlier version:

Fig 1: Identifying Flame Trap Seals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install new seals on the flame trap (lubricate the seals), tighten the seals to 20 Nm .

Install the intake manifold bracket loosely with the lower screw.

NOTE: If the flame trap tip / turns when tightening, make sure that the seals have not rubbed of their necks on the flame trap.