Crankcase ventilation, cleaning: Cleaning
NOTE:
For tightening torques, see:Tightening torque
Remove the banjo screw from the inlet pipe.
Remove the hose (1) from the nipple.
Remove the oil filler cap.
Blow the hose clean (1) using compressed air.
Clean the hose using a ø 2.0 mm cable.
NOTE:
If the hose is blocked use a welding rod (max ø 2.0 mm, approx 250 mm long) to clear the hose.
Clean the nipple (2) using a ø 2.0 mm drill bit or a welding rod.
Install:
- the hose on the nipple
- the banjo screw with new gaskets.
- the oil filler cap.
Raise the vehicle.
Remove the splashguard under the engine.
Tighten the banjo screw.
Install the splashguard under the engine.
Lower the vehicle.