Removal & Installation (Rear Sensor)
WARNING: This page is about a different car, the 1996 Volvo 850. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition is off. Remove wheel. On sedan, fold rear seat forward. Remove trunk mat. Remove fuel pump and fuel level sensor covers. On station wagon, fold up front floor panel and bend mat back. Remove fuel pump and fuel level sensor covers.
- On all models, disconnect wheel sensor electrical connector. Remove wires from opening. Pull wheel sensor wires and connector through from under vehicle. Clean area around wheel sensor. Remove sensor bolt. Remove sensor wires. Remove sensor. To install, reverse removal procedure.