Post-Collision Air Bag Safety Inspection
WARNING: This page is about a different car, the 1996 Volvo 850. However, it is still accessible from the selected car via links, so may be relevant.
POST-COLLISION AIR BAG SAFETY INSPECTION
| Instruction |
Systems |
| Replace After Deployment |
- Air Bag Module(s)
- Contact Reel
- Initiation Wiring To Passenger Module
- Seat Belt Units
- Sensor Module
- Steering Wheel
- SIPS (Sensor Module, Ignition Circuit & Bag Module)
|
| Inspect & If Damaged, Replace Component (Even If Air Bag Did Not Deploy) |
- Dashboard & Frame
- Dashboard Speakers
- Knee Bolsters & Brackets
- Panels Under Dashboard
- Windshield & Moulding
|
| Comments |
- DO NOT attempt SRS wiring repairs.
- Visually inspect SIPS & seats in event of minor collisions without deployment. - Replace if fault code cannot be erased or if there is damage in the area of the Sensor Module.
|