Tachometer Shows Incorrect Value
- Turn ignition on. Activate diagnostic test mode No. 3. See ON-BOARD DIAGNOSTICS (1995 MODELS) under SYSTEM TESTING. Tachometer needle should go to vertical position. If tachometer needle significantly varies from vertical position, check ignition ECU by activating test mode No. 3 on diagnostic unit "A", but placing socket in terminal No. 6. See Figure . If no fault is found in ignition ECU, replace instrument cluster. If tachometer needle goes to vertical position, go to next step.
- Check ground circuit wiring between instrument cluster connector 30-pin connector terminal A15 (Brown wire) and ground. If ground circuit is okay, replace instrument cluster.