Flywheel Assembly: Notes
The flywheel must be aligned properly or the engine will not start. Install flywheel (manual transmission) or drive plate (automatic transmission). Turn crankshaft to top dead center position for cylinder No. 1. Position flywheel/drive plate on crankshaft so that pin A is 15° below horizontal position. See Fig 1.
NOTE:
There are two pins. DO NOT
choose the wrong one.
Install new bolts. Apply sealing compound, P/N 1 161 056-5, to bolt threads. Torque to 50 ft.lbs. (70 N.m). Use gear selector 5112 to lock flywheel.