LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1986 >> 244 Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.3L 4-CYL (B230F) & 2.3L 4-CYL Turbo (B230FT) >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Remove hood and disconnect negative battery cable. Drain coolant and engine oil. Remove distributor cap. Disconnect coolant hoses. Remove radiator, fan shroud, air intake hoses and air cleaner assembly.
  2. Remove power steering pump and A/C compressor with hoses attached (if equipped). Disconnect vacuum hoses, electrical connections, coolant hoses, and control cables at engine.
  3. Remove fuel cap to relieve fuel pressure. Remove fuel lines.
    CAUTION: Use care when removing fuel lines, as pressure may exist in fuel lines.
  4. Raise and support vehicle. Remove splash shield located below engine. Disconnect exhaust pipe at exhaust manifold or turbo. Remove exhaust pipe support bracket.
  5. On 240 series, remove gearshift retaining bolts, bracket and remove gearshift (M/T models) or disconnect control cable (A/T) models.
  6. On 740, 760 and 780 series, remove rubber boot and snap ring at base of gearshift lever, pin and remove gearshift (M/T models) or disconnect control cable (A/T) models.
  7. On all models, disconnect electrical connections and speedometer cable at transmission. Remove drive shaft. Support transmission and remove transmission crossmember. Remove engine mount bolts. Remove engine and transmission assembly.
scientia non olet · About LEMON Manuals