LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1985 >> 245 GLT, Automatic, AW71 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.1L Turbo, 2.3L & 2.3L Turbo >> Crankshaft & Rod Bearings >> Rear Main Bearing Oil Seal >> Installation

Rear Main Bearing Oil Seal: Installation

  1. Clean flange area thoroughly and inspect seal mating surface of crankshaft. Install new seal to flange using drift (2817).
    NOTE: If a new crankshaft has been installed, screw center bolt of tool in fully and install seal at outer position of flange. If crankshaft has not been replaced, install seal with center bolt of tool screwed out a couple of turns.
  2. Oil new seal and install flange with new gasket to cylinder block. Install attaching bolts and tighten. Install oil pan attaching bolts and tighten. Install flywheel, clutch, and transmission.
scientia non olet · About LEMON Manuals