LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1985 >> 245 GLT, Automatic, AW71 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.1L Turbo, 2.3L & 2.3L Turbo >> Crankshaft & Rod Bearings >> Engine Front Cover Oil Seal >> Removal

Engine Front Cover Oil Seal: Removal

  1. Remove fan shroud, fan belt and fan pulley. Remove water pump pulley and camshaft drive belt cover. Remove crankshaft hub, sprocket and belt guide. Remove sprocket from intermediate shaft.
  2. Detach wiring harness across front of engine. Remove 2 oil pan bolts from base of front cover and loosen 2 on each side of them. Remove drive belt guard plate and front cover.
    NOTE: Front cover removal is not necessary if only the seals are being replaced. Pry old seals out and proceed to step 2) of installation.
  3. Using seal driver (5025), press out intermediate shaft seal from front cover. Using similar driver (5024) press out crankshaft seal. Use same tools to install new seals.
scientia non olet · About LEMON Manuals