Disc Pads: Removal
- Raise and support vehicle. Remove tire and wheel. On Girling calipers, remove lock clip; then, remove 1 lock pin while holding damper spring in place. Remove springs and other lock pin.
- On ATE calipers, drive out upper guide pin, and remove tensioning spring. Drive out lower guide pin. Remove disc pads from caliper with Pad Extractor (2917).
- On Bendix calipers, slacken lower sliding pin and lift up caliper. Remove pads. On all calipers, replace pads in sets if lining thickness is less than 1/8" (3 mm). If pads are to be reinstalled, mark for reference.