LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1985 >> 244 GL, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc >> Overhaul >> Master Cylinder >> Reassembly

Master Cylinder: Reassembly

  1. Lubricate all parts with clean brake fluid prior to reassembly. Position washer, seal, and back-up ring on secondary piston.
  2. Install spring thrust washer on piston, and install piston assembly into cylinder bore. Install washer, seal, and back-up ring on primary piston.
  3. Install spring, with plate and sleeve on piston; then install piston assembly into cylinder bore.
  4. Push piston into cylinder bore, and install piston stop screw. Install reservoir sealing rings, and install reservoir.
scientia non olet · About LEMON Manuals