LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1977 >> 242 Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 240 Series 4 Cylinder >> Camshaft >> Engine Front Cover >> Removal

Engine Front Cover: Removal

  1. Remove fan shroud, fan belt and fan pulley. Remove water pump pulley and camshaft drive belt cover. Remove crankshaft hub, sprocket and belt guide. Remove sprocket from intermediate shaft. Detach wiring harness across front of engine. Remove two oil pan bolts from base of front cover and loosen two on each side of them. Remove drive belt guard plate and front cover.
  2. Using suitable tool (5025) press out intermediate shaft seal from front cover. Using similar tool (5024) press out crankshaft seal. Use same tools to install new seals.
scientia non olet · About LEMON Manuals