Hydraulic System Bleeding
NOTE:
To ensure the best possible results, bleed brakes in proper sequence.
- Start at left front brake. Connect bleed tubes to all three bleeder screws and immerse opposite end of tubes in a container partially filled with brake fluid. Pump brake pedal ten times, then keep pedal depressed and using assistants, open all three bleeder screws simultaneously. When pedal reaches end of travel, close all bleeder screws. Continue operation until all air is bled from caliper assembly. Repeat procedure on right front brake.
- Depress brake pedal several times to level out master cylinder. Connect a bleed tube to right rear brake bleeder screw and immerse opposite end of tube in a container partially filled with brake fluid. Open bleeder screw and gravity bleed (no pumping of pedal) caliper assembly. Close bleeder screw when brake fluid is free of air bubbles. Repeat procedure on left rear brake.