Oil Pan Removal
- Using suitable lifting device, raise front of engine. Place jack stands under front jack points. Drain crankcase. Remove lower engine mounting nuts. Remove steering rod from pitman arm.
- Place jacking device under front axle member, remove two rear bolts and replace with two 1/2-13x9" auxiliary bolts. Remove front axle member bolts and lower and remove jacking device so that front axle member is suspended in two auxiliary bolts. Disconnect oil temperature gauge fitting and reinforcing bracket at clutch housing. Remove oil pan bolts and oil pan. Reinstall all related parts in reverse of removal procedure. Replace long auxiliary bolts with original bolts.