B 20 E & F Engines
- Remove positive battery cable. Remove pressure sensor hose, fuel hose for cold start valve, and fuel hoses from pipes at fire wall.
- Remove electrical lead for temperature sensor, cold start valve and throttle valve switch. Remove hose for air intake, ground from intake duct, and pressure regulator. Remove injectors and plug openings.
- Remove throttle bracket and cable. Remove remaining electrical leads. Remove heater hose, vacuum hoses, spark plug wires, and distributor cap. Drain and remove radiator, with expansion tank.
- Remove front engine mount nuts and exhaust manifold flange. Attach suitable hoist. Remove ground strap, clutch linkage, transmission crossmember, speedometer cable, and drive shaft. Remove engine from vehicle. To install, reverse removal procedure.