Removal & Installation
- Loosen fan belt, remove fan and pulley from water pump. Disconnect stabilizer attachment from frame. Take off bolt and remove crankshaft belt pulley.
- Remove front cover case. Loosen several front bolts for oil pan sump, taking care not to damage gasket. Remove circlip, washer, and felt ring from case.
- Replace front cover gasket. Ensure that oil drain hole in casing is open. Place case in position and fit bolts without tightening. Center case using suitable tool (SVO-2438 or equivalent), turn tool while tightening bolts and adjust position of case so that tool is not jammed. Tighten all bolts and remove tool.
- Fit new felt ring washer and circlip. Push into position using centering tool, check to ensure that circlip is in groove. Fit all other parts in reverse order of removal. Tighten belts and place stabilizer attachment back onto frame.
CAMSHAFT
| Engine | Journal Diam. In. (mm) | Clearance In. (mm) | Lobe Lift In. (mm) | |
|---|---|---|---|---|
| 1968-73 | ||||
| All Models | ||||
| Front | 1.8494-1.8504 (46.97-47.00) | .0008-.0030 (.020-.076) | ..... | |
| 1 | 1.6916-1.6929 (42.97-43.00) | ..... | ||
| 2 | 1.4557-1.4567 (36.97-37.00) | ..... | ||