Repairing Can Bus Wires

Observe general notes for repairs on the vehicle electrical system. Refer to VEHICLE ELECTRICAL SYSTEM, GENERAL REPAIR INFORMATION .
As a CAN bus wires unshielded, twisted two-wire lines -1 and 2- are used.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
When repairing CAN bus wires, both wires must be same length.
The repair of individual wire leads is not permitted.
The repair of CAN bus wires must take place with the matching cross section.
For the allocation use the Electronic Parts Information (ETKA).
No excess lengths may be created by the repair.
While doing this, no section of the wire, for example in area of crimp connectors -arrows-, may be greater than -A- : 50 mm without twisting of the wires.
Wrap repair locations with yellow adhesive tape to mark a performed repair.

The crimping of cables with connectors has the same procedure as follows.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
The repair locations -arrows- must not be on top of each other.
The color coding for the CAN bus wires can be taken from the wiring diagram Wiring Diagram.