E-Box, Removing And Installing: Removing

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the engine control module and set aside with the connectors attached. Refer to ENGINE CONTROL MODULE -J623-, REMOVING AND INSTALLING .

-- Push the release buttons in direction of -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cover -1-.

-- Release the mounting tab -2- using a screwdriver.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cover -1- in the direction of -arrow-.

-- Cut the lower cable ties on the wiring harness.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the catches -1, 2 and 4- in direction of -arrow-.

-- Remove the fuse panel B -3- and move to the side.

-- Remove the nuts -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bracket for the engine control module -1-.

-- Release the mounting tab -3-.

-- Disengage the engine compartment E-box -2- from the threaded pins.

-- Remove the engine compartment E-box -2- upward.