Motor Mount, Replacing: Installing

Install in the reverse order of removal while noting the following:

-- Apply the mark -5- on the new motor mount -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position and align the motor mount -1- to the subframe -2- with the line -5-.

-- Slide the Thrust Piece:T10620/15  -O- on the Spindle:T10620/4  -K-.

-- Install the nut -6- on the Spindle:T10620/4  -L-.

-- Position the Thrust Piece:T10620/13  -P- to the motor mount -1-, the shorter distance -a- points toward the subframe -2- when doing so.

-- Assemble both halves of the Thrust Piece:T10620/13  -P- with both bolts.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide the Thrust Piece:T10620/12  -N- on the Spindle:T10620/17  -K-.

-- Position the Thrust Piece:T10620/12  -N- on the subframe -2-.

-- The side with the two recesses points to the subframe -2-.

-- Push the Hydraulic Press:VAS 6178  -V- on the Spindle:T10620/17  -K-.

-- Position the Hydraulic Press:VAS 6178  -V- on the Thrust Piece:T10620/12  -N-.

-- Install the Nut:T10205/8-2  -U- on the Spindle:T10620/17  -K-.

-- Install the nut for the Spindle:T10620/4  -6- to the Thrust Piece:T10620/15  -O-.

-- Position and align the cut-out on the Thrust Piece:T10620/12  -N- with the large diameter on the subframe -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Align the Hydraulic Press:VAS 6178  -V- on the Thrust Piece:T10620/12  -N-.

-- The guide from the Bearing Installer - Wheel Hub/Bearing Kit - Nut:T10205/8-2  -U- must be seated in the Bearing Installer - Wheel Hub/Bearing Kit -Thrust Piece:T10205/13  -P-.

-- Align the tools again and tighten the Nut:T10205/8-2  -U-.

-- Tighten both halves of the Thrust Piece:T10620/13  -P- with both bolts.

-- Connect the Foot Pump:VAS 6179  on the Hydraulic Press:VAS 6178  .

-- Operate the Pneumatic/Hydraulic Foot Pump:VAS 6179  . Engage the motor mount -1- with the Hydraulic Press:VAS 6178  -V- inward.

-- Engage the motor mount -1- until the collar almost contacts the Thrust Piece:T10620/13  -P-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- The end of the motor mount -1- is then in the area of the hole -arrow-.

-- Remove the Thrust Piece:T10620/13  -P-.

-- Completely engage the motor mount -1- until the motor mount -3- contacts the subframe -2- -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.