Electronic Damping Control Module -J250-, Removing And Installing: Removing

The Electronic Damping Control Module -J250- will be called control module in the information that follows.

-- If the control module is replaced, the test plan to replace the control module must be performed using the Vehicle Diagnostic Tester.

-- Remove the right luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Disconnect the connector -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the control module -1- on the right side -arrow-.

-- Pull the control module -1- out of the bracket -2- in the -direction of the arrow-.