Airbag Unit With Driver Airbag Igniter N95, Removing And Installing: Installing
Install in the reverse order of removal while noting the following:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Install the connector and press it on until it audibly locks.
-- Secure the connector on the rear side of the airbag unit.
-- Make sure the wires are not pinched.
-- Position the airbag unit in the steering wheel and press on it until it audibly engages.
-- Connect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- Switch the ignition on.
-- Check and clear the DTC memory using the Vehicle Diagnostic Tester.