Thorax Airbag Crash Sensor In The Driver/Front Passenger Side B-Pillar G1101/G1102, Removing And Installing: Removing
Risk of airbag deployment.
Risk of injury.
- Check if the airbag indicator lamp turns on or blinks.
- If the airbag indicator lamp turns on or blinks, the DTC memory must be read.
- If there is a DTC memory entry, the Guided Fault Finding instructions must always be followed.
-- Disconnect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the rear sill panel. Refer to Rear Sill Panel, Removing and Installing .
-- Remove the B-pillar lower trim panel. Refer to B-Pillar Lower Trim Panel, Removing and Installing .
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Remove the bolt -arrow-.
-- Remove the crash sensor -1-.
-- Disconnect the connector -2-.
-- To do this, pull the connector lock -2- out and press it down in the direction of -arrow-.