Checking And Adjusting Conditions
- Tire pressure OK
- The headlamp glass must not be damaged or dirty.
- Reflectors and light sources OK
- Move vehicle back and forth for a few meters or bounce the front and rear of vehicle several times up and down to settle the springs.
- The vehicle and the headlamp adjusting unit must be on level ground.
- Vehicle or headlamp adjusting unit must be aligned.
- Angle dimension must be set.
- The headlamp adjusting unit if equipped must be located in the correct adjustment mode.
- Pay attention to the Headlamp Adjusting Unit Owner's Manual.
- The current software for the Headlamp Adjusting Unit:VAS 621 001 is available on the homepage of the manufacturer.