Rear Lid Tail Lamp, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Make sure that the seal between the body and tail lamp housing seals properly.
The connector must lock into place.

-- Pivot the Left Tail Lamp 2 - MX5- into the rear lid opening from the outside.

-- Align at the top and center.

-- Tighten the Left Tail Lamp 2 -MX5- upper nut first then the lower nut.

-- Perform a function test.