Steering Lock Housing, Removing And Installing: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Ignition/Starter Switch, Installing. Refer to IGNITION/STARTER SWITCH, REMOVING AND INSTALLING .
Lock Cylinder, Installing. Refer to LOCK CYLINDER, REMOVING AND INSTALLING .

-- Install the steering lock housing -3- in the base carrier for the steering column combination switch -2-.

Fig 1: Identifying Shear Bolts, Steering Column Switch Base Carrier And Steering Lock Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide the Steering Column Combination Switch -E595- onto the steering column switch mount until it locks in place.

-- Slide the pre-assembled unit consisting of the steering lock housing, steering column combination switch, and Steering Column Combination Switch -E595- straight onto the steering column until it stops and align it to the threaded holes.

-- Attach the steering lock housing -3- to the steering column with new shear bolts -1-.

-- Tighten the new shear bolts -1- until the bolt heads shear off.

Further installation is performed in reverse order of the removal.