Instrument Cluster -KX2-, REMOVING AND INSTALLING, ALL-DIGITAL INSTRUMENT CLUSTER: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the steering wheel as far back and down as possible. Use the entire steering column adjustment range.

-- Switch the ignition off.

-- Move the ignition key outside of the vehicle to prevent the ignition from switching on unintentionally.

-- Remove the instrument cluster trim. Refer to INSTRUMENT CLUSTER TRIM, REMOVING AND INSTALLING .

-- Remove the bolts -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the Hooks:T10538 -2- as shown on the upper opening on the Instrument Cluster -KX2- -1-.

CAUTION:

The Instrument Cluster -KX2- is engaged in the instrument panel. A greater amount of force is necessary for removal.

-- Loosen the Instrument Cluster -KX2- -1- with the Hooks:T10538 -2- from the instrument cluster catches.

-- Remove the Instrument Cluster -KX2- -1- until the connectors are accessible.

-- Disconnect the connector.

-- Pivot the retaining bracket in the -direction of the arrow- and disconnect the connector.

-- Release and disconnect the connector for the MOST bus.

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps:VAS 6223/9 -1- onto the MOST bus connector -2-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Instrument Cluster -KX2- between the steering wheel and the instrument panel.